VTech CS6649_-2-3 Abridged manual - Manual (Page 12)

2
Call intercept
If you want to talk to the person whose message is being recorded, press or
on a cordless handset.
-�R-
Press /SPEAKER on the telephone base, or lift the corded handset from the
telephone base.
Access the answering system remotely
Dial your telephone number from any touch-tone telephone.
When the system plays your announcement, enter the two-digit remote code.
The preset code is 19.
You can enter one of the following remote commands.
Command Description
1 Play all messages.
2 Play only new messages.
3 Delete a message (during playback).
33 Delete all old messages.
4 Repeat the current message (during playback).
44 Repeat the previous message (during current message playback).
5 Stop.
*5 Hear a list of remote commands.
6 Skip to the next message (during playback).
*7 Record a new announcement.
8 End the call.
0 Turn the answering system on or off.
Hang up or press 8 to end the call.
Add and register a handset
The cordless handsets provided with your telephone system are already registered.
Each handset is assigned a number that displays on the handset. Additional
handsets registered to the telephone system are assigned numbers in the
sequential order. This telephone system accommodates up to five handsets.
You can add new handsets (
CS6609, purchased separately) to your telephone
system. Each handset must be registered with the telephone base before use.
When first purchased and properly charged, each expansion handset displays
To register HS and See manual alternately. You may need to charge the handset
before registering it to the telephone base.
To register a handset:
On the telephone base, press and hold FIND HANDSET
for about four seconds until the IN USE light turns on
and it shows Registering...
On the cordless handset, press QUIET
#
then it shows
Registering... Both the telephone base and cordless
handset show Registered and you hear a beep when
the registration process completes. The registration
process takes about 60 seconds to complete.
Replace a handset
If you want to replace a handset or reassign the designated handset number of a
registered handset, you must deregister all handsets and then individually register
each handset.
To deregister all handsets:
Press and hold FIND HANDSET on the telephone base for about 0 seconds
until the telephone base shows Registering... then De-register? The IN USE
light flashes.
Immediately
press and release MENU/SELECT. The telephone base displays
Please wait.
All handsets show
To register HS and See manual alternately when the
deregistration process completes. The deregistration process takes about
0 seconds to complete.
Troubleshooting
If you have difficulty with your telephone, please try the suggestions below. For
customer service, visit our website at www.vtechphones.com or call (800) 595-95.
In Canada, go to www.vtechcanada.com or call (800) 267-7377.
My telephone does not work at all.
Make sure the battery is installed and charged correctly.
Make sure the power adapter is securely plugged into an outlet not controlled by
a wall switch.
Make sure the telephone line cord is plugged firmly into the telephone base and
the wall jack.
.
2.
3.
4.
.
2.
.
2.
3.
•
•
•
Before registration,
make sure the handset
is not in the charger.