VTech SN6187 Manual - Manual (Page 20)

Getting started
14
Expand your telephone system
This telephone base can support up to 12 handsets/pendants. Each
device must be registered to the telephone base before use.
The handset and pendant come with the package are already registered
to the telephone base.
You can add new handsets (
SN6107, purchased separately) and
new pendants ( SN6166/SN6167, purchased separately) to your
telephone base. Additional handsets are assigned numbers in the
sequential order.
Add and register a handset
When first purchased, each expansion handset shows To register HS,
see manual. The new handset should be charged without interruption
for at least 30 minutes before registering it to the telephone base.
Make sure the handset is out of the telephone base and is put near
the telephone base. Make sure the handset shows To register HS,
see manual. before you begin registration.
To register a handset:
Put the handset in the telephone base. The base
IN USE light turns solid red. The handset shows
Registering... Please wait. Then HANDSET X
Registered appears on the handset. The handset
beeps and the IN USE light on the base turns off.
It takes up to 60 seconds to complete registration.
If registration fails, the handset displays Registration
failed and then To register HS, see manual. Retry the step above.
•
You cannot register a handset if any other system device is in use.
When you already have 12 registered devices and you try to
register another handset to the telephone base, the handset shows
Registration failed. You hear four beeps from the telephone base.
If you have not set the date and time for the telephone system, the
handset will prompt you to set the date and time after it is registered
to the base. To skip setting, press CANCEL.
•
•
•