VTech SN6127_-2 Abridged manual - Manual (Page 9)

Getting started Getting started Getting started
3
IMPORTANT:
Check for a dial tone by pressing . If you hear a dial
tone, the installation is successful.
If you do not hear a dial tone:
Make sure the installation procedures described
above are properly done.
It may be a wiring problem. If you have changed
your telephone service to digital service from a cable
company or a VoIP service provider, the telephone
line may need to be rewired to allow all existing
telephone jacks to work. Contact your cable/VoIP
service provider for more information.
•
•
Handset charger installation
Stays red when
put in charger.
Install the charger
as below.
1. Place the handset in
the telephone base
or handset charger
to charge.
2.
Electrical outlet
not controlled
by a wall switch
Handset charger
power adapter