V-Tech IP-MR18 Manual - Manual (Page 12)

Item Description
Factory
set
Language
To change language.the code format is 4 digits.Please refer
to section 7(Language and UI updateing) for more detail
informations.
01
Tone Select Select the chime of Door Station in calling wait state, 12
chord tunes are available, key in 01 to 12 to select.
03
Tone Volume Adjust the tone volume for dooor station in calling.Range
from 01~15
08
Unlock Code To change unlock code in Common Code Unlock mode, in
4-digits format. 1111 is the default unlock code.
[1111]
Display Mode
To select the Door Station screen menu .If set to 0,the
screen displays the visitor's image when talking.If set to 1,the
screen displays icons when talking.
[0]
Clock ...
To set date and time.
Date format:if set to 0,date format is DD/MM/YY,if set to
1,date format is MM/DD/YY.
Time format: if set to 0,time format is 24 hour standard.If set
to 1,time format is12 hour standard.
Setup Code To change the Program Code. [88888888]
About ...
1. Hardware version---To show the Door Station(including
ACS) hardware information
2. Software version ---To show the Door Station(including
ACS) software information
3. Manufacture Date---To show the manufacturing date
4. Dialing Counts---To show the call operation counts
5. Calls Counts---To show the established calling counts
6. Unlock Counts---To show the unlock operation counts
7. Standby Voltage---To show the voltage that the door
station in standby.
8. Working Voltage---To show the voltage that the door
station in working.
9. Video Standard---PAL or NTSC standard
10. UI_CODE---To show the UI byte counts and check box
11. MCM-VER---To show the version and language for MCM
12. Updated---To show the updated time for UI
Default ...
Restore all Setup parameters to factory default setting,Please
note that this operation is an irreversible
Table 3(Setup):
-10-