V-Tech IP-MR18 Manual - Manual (Page 10)

Basic Tools Detail:
Item Description
Factory
set
ID Code
1.When there is only one door station and no C5-IPC,
set to 0. And set the type of distributor used with it.
When C5-IPC is connected, must not be set to 0.
2. When C5-MDS is connected, be set to from 1~8
according to which port it is connected on the C5-MDS
3. When used as common door station, set to 9
[0-11]
Standalone
Used with
C5-F4
Unlock Timing
To set the time that how long the door keeps open
when door is released. Range from 01 to 99 seconds.
[05]
5 seconds
Unlock Output
To set the unlock mode to match the corresponding
lock.Range from 0 to 1.
0:Power-on-to-Unlock Mode(Normally Open Mode)
1:Power-off-to-Unlock Mode(Normally Closed Mode)
0
Card Memory
To choose to use the memory of door station or that of
C5-IPC when access cards are in use
0-Use memory of DS for access
1-Use C5-IPC for access
0
Doorplate Mode
To choose the input mode when you call monitor. It
can be set to from 1 to 8 digits. totally 8 numbers or 8
letters or mixed are available
4 digits
Audio Options ...
To set the audio match if there is audio problem
caused by bad match.
1. audio match between door station and monitor
2. audio match between door station and guard unit
0
Parameters ... To show the parameters,please refer to table 2.1
Installer Code ... To change door station administrator code [66666666]
Default ...
To retrieve the original configuration of door station.
Note this operation is an irreversible operation. Once
restore is done, the parameters including Installer
Code and Setup Code will return to factory default
Table 2(Installer Setup):
-8 -