Velleman projects K8044 Assembly instructions - Manual (Page 6)

6
q RX (for each output)
G
These resistors are not supplied whit this kit!
Construction
q CH... : depending on the number of channels
q RX ‘
∗
’
‘
∗’
ATTENTION : In case you use light bulbs, Cold-Cathode
fluorescent lamps & “solid-state” relays mount for RX a jumper
wire, If using LED’s as output indication then mount for RX a
resistor appropriated to the value of the LED. See step 2.
1. Jumper
2. Resistors ‘RX’
Type of LED
Standard (Red) 1K 820
White 470 330
Yellow / Green 1K 820
Blue 470 390
R...