Velleman projects K2655 Assembly instructions - Manual (Page 3)

3
Assembly hints
1. Assembly (Skipping this can lead to troubles ! )
Ok, so we have your attention. These hints will help you to make this project successful. Read them carefully.
1.1 Make sure you have the right tools:
 A good quality soldering iron (25-40W) with a small tip.
 Wipe it often on a wet sponge or cloth, to keep it clean; then apply solder to the tip, to give it a wet look. This is called ‘thinning’ and will
protect the tip, and enables you to make good connections. When solder rolls off the tip, it needs cleaning.
 Thin raisin-core solder. Do not use any flux or grease.
 A diagonal cutter to trim excess wires. To avoid injury when cutting excess leads, hold the lead so they
cannot fly towards the eyes.
 Needle nose pliers, for bending leads, or to hold components in place.
 Small blade and Phillips screwdrivers. A basic range is fine.
For some projects, a basic multi-meter is required, or might be handy
1.2 Assembly Hints :
 
Make sure the skill level matches your experience, to avoid disappointments.
 
Follow the instructions carefully. Read and understand the entire step before you perform each operation.
 
Perform the assembly in the correct order as stated in this manual
 
Position all parts on the PCB (Printed Circuit Board) as shown on the drawings.
 
Values on the circuit diagram are subject to changes.
 
Values in this assembly guide are correct*
 
Use the check-boxes to mark your progress.
 
Please read the included information on safety and customer service
* Typographical inaccuracies excluded. Always look for possible last minute manual updates, indicated as ‘NOTE’ on a separate leaflet.
0.000
H2655IP'1_rev3.pub
page 3 Friday, December 07, 2012 16:58