Spicer N400I Axles User Manual
Spicer, Axles & brakes, Correct position wrong position

Spicer
®
Axles & Brakes
P/N: SHAIS128
SUBJECT:
Output Shaft Snap Ring Installation Instructions for N340 and N400I Axles
Shown below are installations and a procedure for the proper installation of an output shaft snap ring
for N340 and N400I front drive axle assemblies. If the opening of the snap ring is not aligned with the
oil feed path of the bearing cage, oil flow to the output shaft bearings is significantly reduced. This can
shorten bearing life and cause premature bearing failures.
Snap Ring Installation Steps:
1. Install outer bearing cone.
2. Install snap ring with the proper pliers.
3. Rotate the snap ring so that the opening or gap is lined up with the oil feed path in the bearing cage (see drawing below).
4. Install output seal.
Correct Position
Wrong Position
Oil Feed Paths
For spec’ing or service assistance, call 1-800-
621-8084 24 hours a day, 7 days a week
Or visit our web site at:
http://www.
spicerparts.com
Dana Corporation
Copyright Dana Corporation, 2001
Commercial Vehicle Axle Division
SHAIS128A May 2001
All Rights Reserved.
P.O. Box
321
Printed in U.S.A.
www.dana.com
Toledo, Ohio 43697-0321
Snap Ring