QNAP Security VioStor NVR (Version: 4.1.1) User Manual
Page 74
74
Note:
1.
Enabling or disabling the manual recording feature will not affect the scheduled or
alarm recording.
2.
By default, the snapshots are saved in ‘My Documents’ or ‘Documents’> ‘Snapshots’
on Windows.
3.
If the snapshot time is inconsistent with the actual time that the snapshot is taken, it
is caused by the network environment but not a system error.
4.
When the digital zoom function is enabled on multiple IP cameras, the zooming
function will be affected if the computer performance is not high enough.
Right click the monitoring channel on the live view page. The following functions are
available depending on the IP camera model.
a. Connect to camera homepage.
b. Camera setting: Enter the configuration page of the IP camera.
c. PTZ: Pan/Tilt/Zoom camera control.
d. Preset: Select the preset positions of the PTZ camera.
e. Enable live tracking: Available on Panasonic NS202(A) camera.
f. Disable live tracking: Available on Panasonic NS202(A) camera.
g. Auto cruising: This feature is used to configure the PTZ cameras to cruise according to
the preset positions and the staying time set for each preset position.
h. Digital zoom: Enable/disable digital zoom.
i. Keep aspect ratio.
j. Dewarp fisheye images: for Vivotek FE8171V/ FE8172
Right click the channel and enable the function. After that, you can select Mount type,
including wall, ceiling, and floor and then select Dewarping mode, including Panorama
(Full View), Panorama (Dual View), and Rectangle.
Remark 1: The camera firmware version should be v0100h or above. About the latest
camera firmware, please visit
Remark 2: If the Mount type is Wall, only Panorama (Full View), and Rectangle are
supported in Dewarping mode.
Remark 3: If Dewarping mode is Rectangle, you can use PTZ control panel to operate
PTZ functions, excluding digital zoom.