Ohaus CARAT & GOLD LIGHT PORTABLE JEWELRY BALANCES Manual multi - Manual (Page 18)

TAJ Carat / Gold Balances EN-10
4.2.2 Unit Menu
[ U.n.i.t]
Each Weighing Unit may be individually set to
On or OFF.
See Table 4-1 for the symbols associated with each Unit or Mode.
4.2.3 Other Menus
Additional Menus are available if a serial interface option is installed in the balance.
These menus are explained within the user manual of each option kit.
4.3. Calibration Lock Feature
Sliding the switch fully to the lock position prevents calibration of the balance. Using
a paper or wire seal will physically secure the switch if required.
Locking the calibration Adhesive paper seal Wire or plastic tie seal
Figure 4-1. Locking and Sealing the Calibration Lock Switch.
4.4 Weigh Below Feature
The Weigh Below Hook is stored inside the battery cover. Thread the hook into the
access hole at the bottom of the balance. Mount the balance onto an appropriate
assembly that allows free working space below the hook. See Figure 4-2. Note: Never
allow the balance to rest directly on the hook.
Weigh Below Hook access hole
Figure 4-2. Setup for using the Weigh Below Hook.