Ohaus CARAT & GOLD LIGHT PORTABLE JEWELRY BALANCES Manual multi - Manual (Page 14)

TAJ Carat / Gold Balances EN-6
3. OPERATION
Press Zero to zero the balance and then place objects to be weighed on the pan.
Some weighing Modes and Units of measure may initially be unavailable. They can be
enabled in the Main menu Unit
[U.n.i.t], see section 4.
3.1 Weighing Units
Press Unit to advance to next available weighing Unit.
3.2 Weighing Modes
To access other weighing modes - Press and hold Mode until display shows desired
mode. To exit weighing modes - Press and hold Mode until the prior weighing unit is
shown.
3.2.1 Parts Count Mode
Use the Count mode to count parts of uniform weight
To begin Parts Counting, press On-Zero to tare a container or to set the display to zero.
Access Count Mode - Press and hold Mode until the display shows PC. [
CLr.APU] is
displayed.
Establish an Average Piece Weight (APW) - Each time a new type of part is to be
counted, the nominal weight of one piece (Average Piece Weight) must be established
using a small quantity of pieces.
With Clear APW [
CLr.APU] displayed, press No to use the previously saved APW, or
press Yes to establish a new APW. The display indicates the number of pieces to be
used to establish the new APW.
If a different sample size is preferred, press No until the desired sample size is displayed
(5, 10, 20, 50, or 100). Put the specified number of pieces on the pan. Press Yes to
accept new APW. After the new APW is established, the number of pieces is shown on
the display.