Hotchkis 22832R Audi RS4 Sport Rear Sway Bar - Manual (Page 5)

6/ Lift the bar up to the vehicle with the two smaller H-Sport stickers at the
ends right-side-up. As you lift the bar up to the mounting points, you must
place one mounting plate per side between the bushing and the mounting
point. This relocates the bushing out of the stock bushing pocket. Re-install the
bracket nuts and tighten. Re-install the end link bolts and tighten well using
medium strength thread locker
.
**Note** If vehicle is raised using jack stands or other, the bar end and the
end link may not align properly. Lower vehicle so that front suspension is
not at full droop and ends will align. Be sure to thread end link bolt by
hand at first to prevent cross-threading
.
8/
Re-install the aero pan.
Enjoy your new tubular sway bar kit from Hotchkis! If you need assistance with
the install or have any other questions, go to the ‘instructions’ button on our site
or call us at the number below.
Thank you for choosing the best anti-roll bar kit available for your S4 and A4!
Hotchkis
12035 Burke St. Suite 13
Santa Fe Springs, CA 90670
www.hotchkis.net