Hotchkis 22822 Audi A6 Sport Sway Bar Set Black - Manual (Page 5)

2/
Once vehicle is raised, use a standard screwdriver and remove the aero-
pan fasteners. Then remove the pan entirely exposing the anti-roll bar.
3/
Take a moment and observe the stock front bar and the way in
which it is mounted.
4/
Remove the lower end link bolts and nuts (16mm wrench) to the bar and
save only the bolts for re-installation. Remove the four bushing bracket nuts and
save. (13mm wrench) Remove the stock bar.
5/
Apply a quarter tube of grease to each inner-channeled portion of
the two new front bushings and attach to HSport bar against the outside of the
washers on the bar. Slip the new brackets over the bushings.
6/
Lift the bar up to the vehicle. The two smaller HSport stickers at the bar’s
ends should be right-side-up. As you lift the bar up to the mounting points, you
must place one mounting plate per side between the bushing and the
mounting point.
This relocates the bushing out of the stock bushing pocket.