Hotchkis 22834R BMW E90 - E92 Rear Sport Sway Bar - Manual (Page 9)

8R
Disconnect Bushing Brackets & Remove Stock Bar
Remove the sway bar brackets and bushings, and pull the sway bar out from the Drivers side
of the vehicle. The bushing brackets may be stuck onto the bushings, so you may need to
spray WD-40 and have a little patience getting them off.
9R
Install Hotchkis Rear Sway Bar
Install the new sway bar in the same manner it was removed.
10R
Install Hotchkis Bushing Brackets
Grease the new urethane bushings with the supplied grease, and install with the new brackets
onto the sway bar. Make sure to use the supplied flat cut washers with the factory bolts, and
install with blue lock-tight.
11R
Finish Installation in Reverse Order
Finish the installation in the reverse order that everything was removed. Make sure to use blue
lock-tight on the end-link nuts.