Hotchkis 25407 WRX Competition End Link Set - Manual (Page 3)

INSTALLATION OF HOTCHKIS REAR ENDLINKS
This is how the Hotchkis Tuning end link should look when installed in a vehicle with our anti-roll bar. The end link itself is not
symmetric and should be installed in only one direction as shown. Use the included 10MM bolts, large washers and Nylock nuts on the
BOTH ends of the endlink where it connects to the stabilizer bar. Please make sure you install the large diameter washer on both
sides of each bolt. You may damage the bushing if you forget the washer! Tighten the bolts to 45-50 ft/lbs of torque. Cover the zerk
fittings with the included caps to protect them. Re-check the hardware tightness after the first 100 miles.
IMPORTANT: For proper maintenance. If the end links seem to be making too much noise you may need to lube the bushings. Use
a non-lithium based grease to lubricate the bushings using the attached zerk fittings. Lithium grease can be washed out by water and
should not be used.
SEE NEXT PAGE FOR PARTS LIST