Hotchkis 19410 Lexus IS 300 Sport Coil Springs - Manual (Page 6)

16) Re-install the end link. Slide the stud on the end link through the bracket and spindle. Use a
17mm wrench to tighten the stock nut onto the stud. Slide the lower strut bolt through the
bracket and the bottom of the strut. Use a 17mm socket or wrench to tighten the nut and bolt.
Torque both nuts to 30 ft/lbs.
17) Re-attach the end link to the sway bar. Use a 5mm Allen wrench and a 14mm wrench to tighten
the end link. Tighten the end link hardware to 25 ft/lbs.
18) Use a 10mm wrench or socket to re-attach the brake line to the strut using the stock screw.
Torque the hardware to 15 ft/lbs. Use a 10mm wrench to re-attach the ride height sensor on the
driver’s side if you’re installing that side. Torque the hardware to 15 ft/lbs.