Hotchkis 2205 1978-1996 GM B-Body Sport Sway Bars Sedan - Manual (Page 2)

REAR SWAY BAR REMOVAL AND INSTALLATION
1) Raise vehicle and place on jack stands. (make sure the surface is flat; ramps are ok)
2) FOR THE 2205 ONLY
3) If using the stock lower trailing arms, inspect sway bar mount locations for cracking
or damage. We recommend our fabricated trailing arms for improved traction and
performance. SEE ABOVE FOR APPLICATION.
- Using a floor jack, support the sway bar. Remove the bolts
holding the sway bar to the trailing arms. Lower the sway bar and remove.
4) Install new rear sway bar bolts to 45 ft./lbs.
5) Check for exhaust clearance on aftermarket exhaust systems and lower car off of jack
stands or ramps.