High Lifter Arched Rear Lower Control Arms for Polaris Ranger 900 - Pro Series - Manual (Page 3)

3
Installation Instructions:
1. Place jack under center of Ranger rear end and lift until rear wheels clear the
ground. Be careful to support the UTV properly so that it is securely supported
but so that A-arms and shocks can droop to full extension.
2. Remove rear wheels.
3. Remove both rear lower A-arms from the UTV.
Disconnect the lower hub assembly from the lower control arm
Disconnect the shock from the shock mount
Disconnect the lower control arm from the frame
4. Remove the bushings and sleeves from the stock control arms. You will need to
reuse these in the new lower arched a-arm kit.