High Lifter Daylight Kit for Yamaha Grizzly 660 - Manual

High Lifter Products, Inc. (318) 524-2270
780 Professional N. Dr. Fax (318) 524-2297
Shreveport, LA 71105
Yamaha Headlight & Mount
Installation Instructions
This light is simply spliced into the existing Yamaha headlight circuit behind either
headlight. When installed correctly the light will come on when the headlights are turned
on and will change from hi to low beam using the handlebar switch.
If you want to be able to turn this light off but leave the headlights on, simply install a
toggle switch in the ground circuit.
1. Install the light onto the bracket using the nut that is on the light.
2. Mount the light bracket to the handlebars using the 2 U-bolts and 4 Nylock nuts.
3. Using an ice pick or similar tool perforate the rubber plug in the Hella light
housing and thread the wires through the rubber plug. (Before stripping
insulation).
4. Install the Halogen bulb in the headlight being careful not to touch the bulb.
5. Install the black plastic connector inside the light housing.
6. Install the wires in the connector by pressing the clamps then inserting the wires
into the connector. (strip about ¼” of insulation)
7. Using test light, identify wires (ground, high beam, and low beam) to be spliced
(see attached diagram).
8. Disconnect ATV battery to prevent blown fuses.
9. Using the quick splice connectors attach the new wiring according to the diagram.
Verify continuity.
10. Trim excess wire; secure wire from hazards or potential abrasions. Reconnect
ATV battery.
Enjoy the new light and increased safety.
Packing List
12g White Wire-5’ 12g Red Wire-5’ 12g Black Wire-5’
10g-12g Quick Splice-3 Light Mount-1 Bulb-1
Connector-1 Light w/housing-1 U-blots 2ea
Nylock Nuts 4ea