High Lifter Lift Kit for Yamaha Rhino 700 (08-13) - Manual (Page 5)

Rear Lift
1) Place jack under ATV at the rear of the bottom skid plate and lift until the weight is off of the
suspension. Be careful to secure the ATV properly so as not to fall off the jack.
2) Remove the rear wheels.
3) Remove the knuckle assembly from both sides.
4) Remove the shock from the ATV and secure the rear CV axles out of the way.
5) At this point exchange the rear knuckle assemblies and flip them upside down. This is very important
to the function of the lift. (Place the left on the right and the right on the left and install them
upside down)
6) There is a washer welded on the outside of the lower shock mount (Rear Side) that will need to be
completely removed. This can be done using a grinder. You are grinding to clearance the axle.
NOTE: GRIND SIDE NEAREST AXLE
7) Once you have completed grinding portions of the shock mount reinstall the shock, attaching only the
bottom portion.
8) Replace the stock bolt with the 12 x 70 button head bolt and 12mm lock nut. Make sure that the head
of the bolt is closest to the CV axle bar.