High Lifter GUARDS CVBG HLP DP F HONDA 650 RINCON 03-05 - Manual

High
Lifter Products, Inc. (318) 524-2270
780 Professional N. Dr. Fax (318) 524-2297
Shreveport, LA 71105
Honda 650 Front CV Guards
(NOTE: DOES NOT WORK ON THE NEW 680/700 RINCON)
Components:
Front CV Covers 1pair
Mounting Brackets 2ea
6mm Lock Nut 6ea
6 x 20 Hex Head Bolt 2ea
6 x 40 Hex head Bolt 6ea
6mm Flat Washer 4ea
NOTE: Views discussed are from looking at the ATV from the front and from under the ATV
looking up.
Installation:
1. Place jack under center on the ATV front end and lift until front wheels clear the ground. Be careful to
support ATV properly so that it is secure.
2. Remove the front wheels.
3. Remove the front plastic CV covers.
4. Place the High Lifter CV guards on the ATV.
5. From the bottom of the ATV insert 1 of the 6 x 30 flat head bolts and 1 of the 6x40 hex head bolts
through the CV guards into the factory bolt holes in the A-arms and secure it with the 6mm lock nuts
and washers. See illustration
Back Side View
6 x 40 Bolt
&
6mm Lock Nut
6x40 Flat Head
6x40 Hex
Head