High Lifter DynoJet Jet Kit for Honda Foreman 450 (98-04) - Manual (Page 2)

STAGE ONE INSTRUCTIONS
1. Remove vacuum slide from carb. Remove stock needle & spacers, noting order of assembly(Fig. A).
2. Install Dynojet needle on groove #4 install stock washer under the e-clip. Install the Dynojet washer above
the E-clip.
3. Remove stock main jet and replace with Dynojet main jet provided. When using the stock exhaust use the
DJ126 below 3000 feet, DJ122 from 3000 to 6000 feet and DJ118 above 6000 feet. When using an aftermarket
exhaust use the DJ130 below 3000 feet, DJ126 from 3000 to 6000 feet and DJ122 above 6000 feet. Be sure
that the jet you are changing is the main jet.
4. Locate the Fuel Mixture Screw (Fig. B). Using a flat blade screwdriver, turn the mixture screw clockwise until it
seats, then turn out 2-1/2 turns .
Q106.002
This is Groove # 1
Fig.B
Fuel Mixture Screw
Main Jet Location
Fig. A
Dynojet Parts
Stock Washer