High Lifter DynoJet Jet Kit for Yamaha Timberwolf (92-01) - Manual (Page 2)

1. Unscrew top carb plate. Disconect throttle cable and remove slide.(Fig. A).
2. Install Dynojet needle on groove# 3 for applications below 5000 feet, groove #2 for above 5000 feet, using all stock spacers. Install the Dynojet
washer above the E-clip.
3. Remove stock main jet. Use the DJ082 below 3000 feet, DJ078 from 3000 to 6000 feet and DJ074 above 6000Feet. Be sure that the jet you are
changing is the main jet.
4. Locate the Fuel Mixture Screw (Fig. B). Using a flat blade screwdriver, turn the mixture screw clockwise until it seats, then turn out 1 turn below
5000 feet or 1/2 above 5000 feet.
STAGE ONE INSTRUCTIONS
This is Groove #1.
Q401.001
Fig. A Fig.B
This is the Fuel Mixture Screw