High Lifter Detroit Locker #4 - Manual (Page 7)

9. Place the differential assembly back into the differential case.
10. Place other half of the differential case over the assembly and close.
Torque: 10mm bolt (36lbf) 8mm bolt (19lbf)
Note: Use LockTite on all bolts before they are torqued.
When sealing the differential case use a solvent less silicone (It is used for motorcycle snowmobile,
watercraft.)
Differential Installation
1. Place the differential back into the ATV.
2. Put the propeller shaft back into the differential. Make sure that proper care has been taken not to get dirt
and other debris on the shaft ends. Apply grease to end before inserting back into differential. Once it is
greased place into differential and set dust boots. Push the differential forward.
3. Tighten all differential mounting hardware according to factory specification.
4. Re-attach the vent tube to the differential.
5. Install the propeller shaft cover and inner fender cover. (If applicable)
Shaft Installation
1. Make sure that the differential is secure and in place.
2. Slide side axle into differential. Rotate shaft slightly to align splines.
3. Once the shaft is in the differential, take the knuckle/brake panel assembly and attach it to the drive shaft.