High Lifter Lift Kit for Yamaha Grizzly 450i (07-12) - Manual (Page 7)

7
Rear Lift Installation
1. Place ATV transmission in park. Place jack under center of ATV rear end and lift until rear
wheels clear the ground. Be careful to support ATV properly so that it is securely supported so
that A-arms and shocks can droop to full extension.
2. Remove rear wheels.
3. Remove top of the rear shocks.
4. Place the Tube bracket on the rear shock mount tabs, while inserting the large spacer between the
shock mount tabs.
5. Secure the bracket to the ATV using the 10mm x 60mm hex bolt and 10mm lock nut.
6. Next, insert the shock into the bottom of the tube bracket.
7. Insert the 10mm flat washer between the top of the shock and the inside of the tube bracket.