High Lifter Lift Kit for Suzuki Ozark 250 2x4 (02-07) - Manual (Page 2)

Front Lift Installation
1) Place jack under center of ATV front end and lift until front wheels clear the ground. Be careful to support
ATV properly so that it is secure, but so that the A-arms and shocks can droop to full extension.
2) Remove front wheels and top of the shock.
3) Place the smaller front round spacer between the shock mount tabs and attach the front lift bracket to the
ATV using a 10x45 hex bolt and 10mm locking nut.
Note: When attaching the front lift bracket, make sure that the smaller side is facing out.
4) Next, attach the shock to the bracket, placing two 10mm flat washers on both sides of the top of the shock,
on the inside of the front lift bracket.
5) Secure the shock to the bracket using one 10x45 hex bolt and 10mm locking nut.
6) Repeat steps for opposite side.
7) Place the wheels back on the ATV and lower jack.