High Lifter Lift Kit for Yamaha Grizzly 660 (02-07) - Manual (Page 2)

2) Remove front wheels.
3) Remove the front shocks.
4) Place the tubing bracket over the top shock mount. (See Illustration A)
5) Secure the tubing bracket to the frame using 10 x 55mm Hex head bolt. Insert two round spacers in
the center of the tubing bracket, sliding the bolt through the round spacers, before fastening tight.
(See Illustrations A-C)
6) Secure the shock to the tubing bracket using 10 x 55mm Hex head bolt. Insert one small round
spacer to the rear (toward the back) of the shock, to the inside of the tubing bracket. (See
Illustrations D-E)
7) On the outside of the tubing bracket, to the right, install the flat twist bracket. (See Illustration F-
G)
Note: There is a left and right bracket. To tell the difference between left and right, once the twist
bracket is attached to the tube bracket, the opposite end of the flat twist bracket will run parallel
to the portion of the frame it will be attached to. (See illustration H )
8) Secure the flat twist bracket to the frame using the small flat bracket and two ¼ x 1 ¾ Hex head
bolts and Nyloc nuts. (See Illustration I)
9) Re-attach lower shock to shock mount.
10) Repeat steps for the opposite side.
11) Place wheels back on the ATV.
12) Torque all nuts to owners manual specifications.
Parts Diagram