VDO Z2 - Manual (Page 44)

35
INSTRUCTION MANUAL
No speed display - Check the magnet position
(distance between magnet
and transmitter, position of the
magnet to the transmitter point
on the transmitter)
- Check the battery in the
transmitter
- Check the battery in the
computer (if battery voltage is
insufficient then the receiver
cannot receive the signals)
No cadence display - Check the magnet position
(distance between magnet
and transmitter, position of the
magnet to the transmitter point
on the transmitter)
- Check the battery in the
transmitter
- Check the battery in the
computer (if battery voltage is
insufficient then the receiver
cannot receive the signals)
No speed display (dash in the
display) The receive channel for speed is
switched off (a 15-minute period
has elapsed without receiving a
speed signal)
Press buttons
¥ + ç at the
same time
No cadence data (dash in the
display) The receive channel for cadence
is switched off (a 15-minute
period has elapsed without
receiving cadence signals)
Press buttons
¥ + ç at the
same time
No pulse display (dash in the
display) The receive channel for pulse is
switched off (a 15-minute period
has elapsed without receiving
pulse data)
Press buttons
¥ + ç at the
same time
No average pulse Timer has not been started
Start timer
No maximum pulse Timer has not been started
Start timer