VDO Z2 User Manual
Page 37
28
EN
TIMER 1: You can program a time e.g. for interval training. TIMER 1
counts from zero forward. At the end of TIMER 1 there is a single beep.
Timer 1 only functions if you have set a time. If you have forgotten to
set a time your VDO computer displays TIMER ERROR
TIMER 2: You can program a time, e.g. for the rest phase in an interval
training. TIMER 2 counts from zero forward. At the end of TIMER 2 there
are two beeps. Timer 2 only functions if you have set a time. If you have
forgotten to set a time your VDO computer displays TIMER ERROR
TIMER 1+2 runs until you stop these functions. Timers 1 + 2 only
function if you have set a time. If you have forgotten to set a time your
VDO computer displays TIMER ERROR.
COUNTDOWN: You can program a time, the timer will count backwards
from this time. At the end of the COUNTDOWN time there is a single
beep. Countdown only functions if you have set a time. If you have
forgotten to set a time your VDO computer will display COUNTDOWN
ERROR.
LAP TIMER: Start Lap Timer with ∫ . Start next Lap with ≈ + ¥ at the
same time at any point of the training unit. The following values will
be saved:
- Duration of the lap
- Average heart rate on the lap
- Average speed on the lap
The lap values can be called at any time if time measurement is
stopped.
STOPWATCH: With the manual stopwatch you can manually capture the
plus values of training units.
12.1. SELECTING THE TIMING FUNCTION
3 sec.
ç
Setting mode LANGUAGE SELECT
∂ ƒ
TIMER SETTINGS
‚
TIMER
?SELECT?
Select
‚
TIMER 1 ?SELECT?
Timer
∂
TIMER 2 ?SELECT?
∂
TIMER 1 + 2 ?SELECT ?
>>> Query repeats TIMER
1 + 2 REPEATS ?SELECT?
∂ COUNTDOWN
?SELECT?
∂ LAP
TIMER
?SELECT?
∂ STOP
WATCH
?SELECT?
‚
Confirm selection SET DONE
If you have not yet set any values for timer 1, timer 2, timer 1 +2, or
countdown, then your VDO computer will now show ERROR in the
display. In this case proceed as explained in the following chapter 12.2
Setting the timer.
12.2. SETTING THE TIMER (when selecting timer 1 or timer 2 or timer 1+2)
Setting times for timer 1/timer 2
3 sec.
ç
Setting mode LANGUAGE SELECT
∂ ƒ
TIMER SETTINGS