High Lifter DynoJet Jet Kit for Honda Rancher 350 (00-05) - Manual (Page 2)

STAGE ONE INSTRUCTIONS
1. Remove vacuum slide from carb. Remove stock needle & spacers, noting order of assembly (Fig. A).
2. Install Dynojet needle on groove# 3 from the top for applications below 6000 feet, groove #2 for above 6000
feet, using all stock spacers. Install the Dynojet washer above the E-clip.
3. Remove stock main jet and replace with Dynojet main provided. If using the stock exhaust use the DJ120
below 3000 feet, DJ116 from 3000 to 6000 feet and DJ112 above 6000 feet. If using an aftermarket exhaust
with a high flow baffle use the DJ124 below 3000 feet, DJ120 from 3000 to 6000 feet and DJ116 above 6000
feet. Be sure that the jet you are changing is the main jet.
4. Locate the fuel mixture screw (Fig. B). Using a flat blade screwdriver, turn the mixture screw clockwise until it
seats, then turn out 3-1/2 turns .
Q108.001
This is Groove # 1
Fig.B
Fuel Mixture Screw
Main Jet Location
Fig. A
Dynojet Parts
Stock Washer