High Lifter Max Clearance Front Lower Control Arms for Polaris RZR 800 "S & "4"" - Manual (Page 3)

3
Installation Instructions:
1. Place jack under center of front end and lift until front wheels clear the ground.
Be careful to support the UTV properly so that it is securely supported but so that
A-arms and shocks can droop to full extension.
2. Remove front wheels.
3. Remove lower A-arm from the UTV. You do not need to remove the front plastic
guard completely. Just remove the two lower bolts that hold it in place. You will
be able to pull the plastic back enough that you can remove the bolt that holds the
lower control arm in place.
4. Remove the bushings, sleeves, and ball joints from the stock control arms. You
will need to reuse these in the new forward a-arm kit.
NOTE: A press or a vise is suggested for removing and replacing the ball
joints. Verify that the clip snaps into place after installing the ball joints into
the new A-arm
5. Install the grease fittings supplied in the kit into the new arms. DO NOT OVER
TORQUE FITTINGS!