High Lifter DynoJet Jet Kit for Honda Foreman 400 (96-03) - Manual (Page 2)

STAGE ONE INSTRUCTIONS
1. Remove vacuum slide from carb. Remove stock needle & spacers, noting order of assembly (Fig.A).
2. Drill slide lift hole with DD31 drill bit supplied.
3. Install Dynojet needle on groove# 3 for applications below 6000 feet, groove #2 for above 6000 feet, using all
stock spacers. Install the Dynojet washer above the E-clip.
4. Remove stock main jet and replace with Dynojet main provided. Use the DJ124 below 3000 feet, DJ120 from
3000 to 6000 feet and DJ116 above 6000Feet. Be sure that the jet you are changing is the main jet.
5. Locate the Fuel Mixture Screw (Fig B). Using a flat blade screwdriver, turn the mixture screw clockwise until it
seats, then turn out 2-1/2 turns .
Q104.001
This is Groove # 1
Fig.B
Fuel Mixture Screw
Main Jet Location
Fig. A
Dynojet Parts
Stock Washer
Drill This Hole
with DD31.