Panasonic AW-RP555 - Manual (Page 5)

4 (E)
ENGLISH
 This unit is a multi hybrid control panel that controls the pan/tilt head system (pan/tilt
head and convertible camera).
 Please use a 10BASE-T straight cable (UTP category 5) to connect to this unit.
 Up to 5 additional pan/tilt head systems may be connected to this unit. The connection
between the pan/tilt head system and this unit may be extended up to 1,000 meters
when using AW-PH360, AW-PH350 or AW-PH650 as the pan/tilt head.
The distance may be extended to 800 meters when using other pan/tilt heads.
 Use cable compensation unit AW-RC400 when using a cable compensator for the video
signal from the pan/tilt head system.
Introduction
AW-PH350, AW-PH360 and AW-PH650
The control signals from the control panel can be connected to these units directly.
AW-PH300, AW-PH300A, AW-PH500 and AW-PH600
The control signals from the control panel must be converted into RS-232C signals
using a 422/232C converter before making the connection to the RS-232C connector
on the pan/tilt head.
Camera control is also performed using the RS-232C interface.
When using AW-PH500 the camera cannot be controlled.
Pan/tilt heads supported
Use the dedicated AC adapter AW-PS505A (sold separately) for the power supply.
Recommended adapter
Please contact a specialist when discarding this unit in consideration of the environment.
Caution
Rack mounting adapters (4U) ........................................................................................... 2
Join-up fixture .................................................................................................................... 1
Mounting screws (M48 mm) .......................................................................................... 8
Accessories