Panasonic AW-RP555 - Manual (Page 13)

12 (E)
ENGLISH
Parts and their functions

OP button
This controls the short- or open-circuiting of the OPTION SW CONTROL OUT
connector of the AC adapter (AW-PS300A) which is connected to the pan/tilt head
system currently selected.
Each time it is pressed, short-circuiting or open-circuiting is selected in turn.
When the connector is short-circuited, the button’s lamp comes on; when it is open-
circuited, the lamp goes off.

LAMP button
This controls the ON and OFF of the halogen lamp which is connected to the pan/tilt
head system currently selected.
Each time it is pressed, the lamp is turned ON or OFF in turn.
When the halogen lamp is ON, the button’s lamp comes on; when it is OFF, the lamp
goes off.
It flashes when the halogen lamp has not been connected or when the lamp has been
disconnected or some other problem has occurred.

SPEED button
This is used to select the control (pan, tilt, zoom, focus, iris) speed of the pan/tilt head
system currently selected.
Each time it is pressed, the high-speed mode or low-speed mode is selected in turn.
The button’s lamp comes on in the low-speed mode, and it remains off in the high-speed
mode.
By pressing the SPEED button while holding down the MEMORY button, it is possible
to set whether the high-speed mode or low-speed mode is to be selected when the
power is turned on (or at OPERATE ON).

ZOOM lever
This is used to adjust the lens zoom in the pan/tilt head system currently selected.
Depending on the direction in which the ZOOM lever is tilted, TELE (telephoto) or WIDE
(wide angle) is set, and depending on the angle at which it is tilted, the zoom speed is
adjusted.

FOCUS lever
This is used to adjust the lens zoom in the pan/tilt head system currently selected. FAR
or NEAR is set by the direction in which the FOCUS lever is tilted, and the focus speed
is adjusted by the angle to which it is tilted.