High Lifter Lift Kit for Arctic Cat 1000 ATVs - Manual (Page 4)

6) Next, insert the bottom of the shock into the top of the tube bracket. Insert the 10mm x 45mm hex bolt
through the front support bracket and then through the tube bracket, small spacer, and shock until it
goes all the way through. Secure it using the 10mm lock nut.
7) Connect the support bracket to the A-arm using the two smaller support bracket and ¼ x 1 ¾ hex bolts
and ¼ lock nuts.
8) Tie Rod and Ends
1. Included in this kit are two replacement tie rods.
2. Mark sure to mark the where the stock tie rod ends on the tie rod end.
4