Herman Miller Mirra Chairs - Disassembly For Recycling - Manual (Page 5)

Z
© 2012 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Mirra, Co/Struc and Embody are among the registered trademarks of Herman Miller, Inc.
TM Sense, Setu, Tu and SAYL are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products. 5
Z Part no. 1b9rtg rev B.
16. By hand, pull adjustable
arm stem cover loose from right
side cover and slide cover off
arm stem.
17. With fingers, grasp bottom
of access cover and carefully
pull out on access cover until
retaining tabs release.
18a. Using ratchet wrench and
13mm socket and10mm allen
key, remove both M10 bolts
from mounting stem.
Note:
Chairs built after 4/29/2011
Allen key engaged
on yoke
15. Remove both slide inserts
from arm stem by pulling out
on inserts. Set inserts and arm
assembly aside.