EVS XTnano Version 10.04 - January 2011 Configuration Manual - Manual (Page 30)

Issue
10.04.A XTnano – Version 10.04 – Configuration Manual
EVS Broadcast Equipment SA – January 2011
22
2.6.2 S
ETTINGS
D
ESCRIPTION
The HCTX Gigabit connection settings are described in the table below:
Port #1 / Port #2
IP Address Specifies the IP address to connect to port 1 / port 2 of the
Gigabit Ethernet connection on the server:
• The IP addresses of both HCTX GigE ports must belong to
different subnet masks. Otherwise, it would return an error
message.
• The IP addresses 0.0.0.0 and 255.255.255.255 are not
allowed.
Subnet Mask Specifies the range of logical addresses within the address
space assigned to the Gigabit Ethernet network.
In the screenshot, the logical addresses available within the
network are from 128.1.254.1 to 128.1.254.254.
Default Gateway Specifies the IP address of the router on the Gigabit
Ethernet network that serves as an access point to external
networks.
FTP Login
User name Specifies the user name for an FTP access to the server via
the Gigabit Ethernet connection.
Password Specifies the password for an FTP access to the server via
the Gigabit Ethernet connection. The password is not hidden.
Note
The modifications of parameter values in this screen are not applied
when you leave the field. You need to select the APPLY option at the
bottom right of the screen and press ENTER to apply the modifications.
2.6.3 L
OST
G
IGABIT
N
ETWORK
C
ONNECTION
If a problem is detected on the GigE connection during operation, the following
message is displayed on the Remote panel, OSD and VGA:
‘ W a r n i n g : G i g E c o n n e c t i o n h a s b e e n l o s t .
[ E n t e r ] : C o n t i n u e ’
In such a case, the message !Not detected! also appears at the top of page 6.