Yamaha DVD-S2300 - Manual (Page 35)

31
English
DET
AILED SETTINGS
This unit features independent playback circuits for DVD
mode and SACD mode. DVD mode settings are not valid
in SACD mode. You must complete a separate group of
settings dedicated to SACD mode.
To play multi-channel Super Audio CD data effectively,
set the speaker parameters in SACD mode to suit your
speakers and components. The speaker parameters enable
you to select a speaker mode and adjust the speaker bal-
ance.
■ Setting speaker mode
Set the speaker mode according to your speaker size and
setup.
1 Press SETUP.
The unit displays “SPK MODE.”
2 Press ENTER.
The unit displays the current setting.
3 Press the cursor button
l l l l or
h h h h to change
the setting.
When you press the cursor button, the speaker mode
setting (indicated on the display) changes as follows:
Speaker mode chart
Selecting a speaker mode:
Select a speaker mode to suit your speaker setup and
performance. Speakers marked “Large” will output
all signals, including a low range of 90Hz and lower.
If you are using a large speaker with a large capacity
for low-range frequencies (i.e., the woofer diameter is
16cm or more), select a mode for which the corre-
sponding speaker is marked “Large.” The low range
on the “Small” speaker channels is output to the sub-
woofer or main speakers (marked “Large”). If you
feel that low range playback is not sufficiently power-
ful, or if the sound clips, select a mode in which the
corresponding speaker is marked “Small.”
4 Press ENTER to confirm the selected mode.
5 Press SETUP.
The unit displays the standard screen.
■ Adjusting the speaker balance
If the volume level of each speaker varies, use the test tone
to adjust the level so that all speakers sound at the same
level as the main speakers.
•
The speaker balance cannot be adjusted if the speaker
mode is set to MLTCH DIRECT.
• If the speaker mode is changed, parameters set prior to
the change will be initialized (assigned as initial val-
ues).
1 Press SETUP.
2 Press the cursor button l l l l or h h h h to select
“SPK BALANCE.”
Pressing the cursor button toggles between “SPK
MODE” and “SPK BALANCE.”
CHANGING THE SACD MODE SETTINGS
Speaker settings
SET UP
ENTER
,
Speaker
mode
Main
speakers
Center
speaker
Rear
speakers
Sub-
woofer
MLTCH
DIRECT
Audio signals are output as recorded.
5-LRG Large Large Large None
5-SML
+SW
Small Small Small Used
MAIN-LRG
+SW
Large Small Small Used
MAIN-LRG Large Small Small None
NON-C
+SW
Large None Large Used
NON-C Large None Large None
DVD-S2300_UA.book Page 31 Thursday, October 3, 2002 11:03 AM