Yamaha DVD-S2300 - Manual (Page 14)

10
PLAYING A DISC
Before playing a disc, you must connect the unit’s audio
and video output jacks to an AV amplifier or other system
component (refer to pages 8 and 9).
Note
• If you digitally connect the unit to an amplifier that does not
feature a DTS decoder, set DTS DIGITAL SURROUND to
PCM (factory default) in the Setup/Audio menu. Otherwise,
unprocessed digital signal noise will be output that may dam-
age your hearing or speakers.
1 Press POWER to turn on the power.
2 Press OPEN/CLOSE to open the disc tray.
3 Load a disc into the disc tray.
4 If necessary, press SACD/DVD to change the
mode.
For more information, refer to “Switching disc play
mode” on page 10 (below).
5 Press w w w w .
The disc tray closes and playback starts.
y
• If one of the following indicators is displayed
refer to “Using disc menus” on
page 13.
• When the unit finishes playing a DVD, it stops playback or dis-
plays a menu screen.
Note
• The unit cannot play CD-R or CD-RW discs that have not been
finalized. Be sure to finalize discs on a CD recorder before
playing them in this unit. (The term “finalize” refers to an
audio process for CD-Rs or CD-RWs that prepares them for
play on supporting players.)
■ Switching disc play mode
While the unit is stopped or the disc tray is
open, press SACD/DVD.
The unit includes independent playback circuits for
SACDs and DVDs to optimize use of each disc type.
•
To play an SACD, switch to SACD mode.
• To play other types of discs, switch to DVD mode.
Use SACD mode to play .
The SACD mode indicator lights up.
Use DVD mode to play , , , and
The DVD mode indicator lights up.
y
• If you are playing a hybrid disc that contains both SACD for-
mat data and conventional CD format data, select SACD mode
to play the SACD format data, or DVD mode to play the CD
format data.
■ To stop playback
Press a .
■ Resume function
The unit retains memory of the point at which you pressed
the
a button as long as the power to the unit is turned on.
During this time, the W W W W indicator will flash on the display.
Press w to resume playback from the stop point.
PLAYING A DISC
Before starting playback
Basic operation
POWER
SACD/DVD OPEN/CLOSE
DVD/SACD mode
indicator
DVD-A DVD-V VCD
SACD
DVD-A DVD-V VCD
CD
DVD-S2300_UA.book Page 10 Thursday, October 3, 2002 11:03 AM