Blue Ox BX88100 - Manual (Page 6)

BX88100
Universal AutoStop™
Operation Manual & Installation Instructions
292-2215 Rev A Page 6 of 12 10/30/13
10. Gather up the wires and the relay. Anchor them up out of the way so they will not interfere with
driving the vehicle with wire ties.
continued to previous page
WARNING: Motorhome dash light must be installed according to installation instructions or warranty
will be void.
RV DASH LIGHT
1. Dash light will allow a visual indication that the towed vehicles' brakes are activated.
2. Should light remain "ON" after braking, corrective action must be taken. "STOP" the RV to
investigate. You may be experiencing a malfunction of the system, which would require you to
check, the braking system for proper operation.
a. Cable tension should comply with the installation instructions.
b. Check wiring of relay in towed vehicle to insure proper installation.
c. If breakaway device is installed, refer to its installation instructions.
3. Should dash light activate while turning, corrective action must be taken. “STOP” the RV to
investigate.
a. If readjustment of cable is needed, this is usually an indication that the cable is too tight or
. is hanging up on one of the towing components.
TESTING
The electrical installation can be tested to see if it is installed correctly. When applying the brakes
with the key in the off and the accessory position, the rear brake lights should not come on, but when
applying the brakes with the key in the on position, the brake lights should come on.
Figure 8