ACU-RITE DRO 200M - Manual (Page 22)

DRO 200M Readout Operations
15
X
Y
1
8
7
6
5
4
3
2
X
Y
210°
30°
For partial bolt hole patterns, you need to enter an end angle.
Using the Result
After you have defined the bolt hole pattern, press the USE key to use the
results. Each time you press USE , the readout displays the hole number briefly,
then presets the X and Y location for that hole. All you have to do is move to zero
and drill the hole.
The readout will remember the hole pattern until you change it. This means that
you can return to any of the holes at any time—just press
USE .
If you need to go to a specific hole, just enter its number after the USE key.
This 5-hole bolt hole
pattern starts at 30º, and
ends at 210º.
USE
ENTER 5