Acura 2012 ZDX - Manual (Page 345)

343
uu Fuses u Inspecting and Changing Fuses
Handling the Unexpe
cte
d
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK 0 *1 . Turn
headlights and all accessories off.
2. Remove the fuse box cover.
3. Check the large fuse in the engine
compartment.
u If the fuse is blown, use a Phillips-head
screwdriver to remove the screw and
replace it with a new one.
4. Inspect the small fuses in the engine
compartment and the vehicle interior.
u If there is a burned out fuse, remove it
with the fuse puller and replace it with a
new one.
*1: Models with the keyless access system have an ENGINE START/STOP button
instead of an ignition switch.
1 Inspecting and Changing Fuses
NOTICE
Replacing a fuse with one that has a higher rating
greatly increases the chances of damaging the
electrical system.
Replace fuse with a spare fuse of the same specified
amperage.
Use the charts to locate the fuse in question and
confirm the specified amperage on the fuse label.
2 Fuse Locations P. 338
There is a fuse puller on the back of the engine
compartment fuse box.
Blown Fuse Fuse
Combined Fuse
Blown Fuse
Fuse Puller