Acura 2012 RDX - Manual (Page 92)

If ‘‘DEFAULT ALL’’ is not set, you
will see the above display for several
seconds, then the screen goes back
to
‘‘CUSTOMIZE ENTRY.’’ Repeat
the procedure to select ‘‘DEFAULT
ALL. ’’
If you want to cancel ‘‘DEFAULT
ALL, ’’ select ‘‘EXIT,’’ then press the
SEL/RESET button. The screen
goes back to
‘‘CUSTOMIZE
ENTRY. ’’
Change Settings
You can customize some of the
vehicle control settings to your
preference. Here are the settings you
can customize:
●
METER SETUP
● LIGHTING SETUP
● DOOR SETUP
While ‘‘CHG SETTING’’ in the
‘‘CUSTOMIZE ENTRY’’ is shown on
the multi-information display, press
the SEL/RESET button. The screen
changes to
‘‘METER SETUP’’ in the
‘‘CUSTOMIZE GROUP.’’
Each time you press the INFO ( /
) button, the screen changes as
shown on the next page. Press the
INFO ( / ) button, until you see
the setup you want to customize,
then press the SEL/RESET button to
enter your selection.
Multi-Information Display
86
11/06/16 17:42:51 12 ACURA RDX MMC North America Owner's M 50 31STK650 enu