Acura 2014 RLX - Manual (Page 142)

141
uu Operating the Switches Around the Steering Wheel u Wipers and Washers
Continued
Wipers and Washers
The windshield wipers and washers can be
used when the power mode is in ON.
■
MIST
The wipers run at high speed until you release
the lever.
■ Wiper switch (OFF, INT * , LO, HI)
Change the wiper switch setting according to
the amount of rain.
■ AUTO *
2 Automatic Intermittent Wipers * P. 142
■
Adjusting the delay
Turn the adjustment ring to adjust the wiper
delay.
■
Washer
Sprays while you pull the lever toward you.
When you release the lever, the wipers make
two or three more sweeps before stopping.
1 Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get scratched, or the rubber
blades will get damaged.
NOTICE
In cold weather, the blades may freeze to the
windshield, becoming stuck.
Operating the wipers in this condition may damage
them. Use the defroster to warm the windshield,
then turn the wipers on.
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens.
When the vehicle starts moving, the wipers make a
single sweep.
When the vehicle speeds up, the wiper operation’s
shortest delay setting ( ) and the LO setting become
the same.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
The wiper motor may stop motor operation
temporarily to prevent an overload. Wiper operation
will return to normal within a few minutes, once the
circuit has returned to normal.
a MIST
c INT * : Low speed with
intermittent
b OFF
d LO: Low speed wipe
e HI: High speed wipe
Pull to
use
washer.
a
b
c
d
e
AUTO * : Wiper speed varies
automatically
Long delay
Short delay
* Not available on all models
14 ACURA RLX-31TY26000.book 141 ページ ２０１３年３月１８日 月曜日 午後３時１８分
QRG
Index
2014 RLX
C
o
n
tr
o
ls
TOC