AcuRite 00973 Weather Station - Manual (Page 3)

5 PREVIEW THE DISPLAY
Main Unit - Upper Display - Weather
Main Unit – Lower Display – Date and Clock
Using the included LOW TEMPERATURE ADAPTOR
MON TUE WED THU FRI SAT SUN
MOON
REMOTE MAIN UNIT
0 -1 -2 -3 -6 -12
-.24
-.18
-.12
-.06
0
+.06
+.12
+.18
+.24
- 8
- 6
- 4
- 2
0
+2
+4
+6
+8 > >
> >
inHg/Hr Hr/hPa
INDOOR OUTDOOR
PRESSURE
FORECAST
Weather Forecast
Graph shows air pressure history
Alarm has
been set
Moon Phase Antenna is
receiving the
time & date
signal
Low Battery Indicators
Month/
Date/
Day
Barometric
Pressure at a
given hour.
Outdoor Temperature
& Humidity
Wireless sensor channel Number
Indoor Temperature
& Humidity
Minimum/
Maximum
memory
mode
indicator
5 4
0
NORMAL
TEMPERATURES
NORMAL
TEMPERATURES
Wireless Sensor is
weather-resistant and
can be placed outdoors
The wireless sensor will operate normally down to -4 ºF. Below -4 ºF, the electronics
may operate erratically or become non-functional until the temperature raises again.
In case temperatures fall below -4ºF, bring the wireless sensor indoors and use the
included low temperature adaptor by running the wire out through a soft seal opening
such as a window or door. When routing the wire for the low temperature adaptor,
make certain that the wire will not be severed or damaged.
WIRELESS
SENSOR
LOW-TEMP.
ADAPTOR
LOW-TEMP.
SENSOR
EXTREMELY LOW
TEMPERATURES
low-temp adaptor
is used outside to
observe temperature
Wireless Sensor is
protected indoors in
extreme temperatures
INDOOR OUTDOOR
-4 ºF
NOTE: The wired TEMPERATURE ADAPTOR only observes temperature, not humidity.
If the adaptor is placed outdoors, and the wireless sensor is indoors- the wireless
sensor will only transmit the indoor humidity reading & the outdoor temp. reading.
Wireless Sensor - Display
Press the “MODE” button inside the back of the wireless sensor to display temperature
and/or humidity in one of three ways:
1)Temperature continuously,
2)Humidity continuously, or
3)Temperature for 5 seconds, then humidity for 5 seconds
NOTE: The sensor’s display setting does not affect the main unit’s display.
86.
5
F 1
25
1
86.
5
F 1
25
1
Channel
(sensor #)
(Alternate icon)
Display Mode 1
(Temperature) Display Mode 2
(Humidity)
Display Mode 3
(alternating temp. & Humidity)
press
“mode”
button
press
“mode”
button
EXTREMELY LOW
TEMPERATURES
OR LOWER