AcuRite 01098 Weather Station - Manual (Page 3)

Setup Indicators
will be located
in this area
Press and hold the “ ” (SET) button for 3 seconds to enter in to SET
MODE. Once in set mode, the preference you are currently setting will blink
on the display.
To adjust the currently selected (flashing) preference item, press the “ ”
or “ ” buttons. (press and HOLD to fast adjust).
To save your adjustments, press the “ ” button again to move on to
adjusting the next preference. The preference set order is as follows:
TIME ZONE (PST MST CST EST AST HAST AKST) **REQUIRED**
DST (Daylight Saving Time ON or OFF) **REQUIRED**
CLOCK HOUR
CLOCK MINUTE
CALENDAR MONTH
CALENDAR DATE
CALENDAR YEAR
TEMPERATURE SCALE (ºF or ºC)
BAROMETRIC PRESSURE SCALE (inHg or hPa)
You will automatically exit SET MODE if no buttons are depressed for 30
seconds. You may enter basic setup mode again at any time by pressing the
“ ” button.
Display Unit : Basic Setup
4 3
SETUP PLACEMENT
Place the display unit in a dry area free of dirt and dust. To help
ensure an accurate indoor temperature and humidity measurement,
be sure to place the display unit out of direct sunlight, and away
from any heat sources or vents in your home. There are 2 placement
options for the display unit. You may hang the main unit on a wall
using the integrated hang hole. Alternatively, you may place the
main unit on a table top or other flat surface using the included table
top display stand.
Placement of Display Unit
Now that setup is complete, you must choose a location to place the sensor
and the display unit. The sensor MUST be placed less than 330 feet (100
meters) away from the display unit.
This weather station uses radio frequency for communication, which is
susceptible to interference from other electronic devices and large metallic
items or thick walls. Always place both units at least 3 feet (.91 m) away from
appliances ( TV, microwave, radios, etc. ) or objects that may interfere with
the wireless communication ( large metal surfaces, thick stone walls, etc. ).
About the Intelli-Time
®
Clock
This weather station is equipped with Intelli-Time ® technology. Intelli-Time clock
adjusts itself for Daylight Saving Time (DST). All you need to do is select your
Time Zone and Daylight Saving Time preferences.
Basic Setup is Now Complete
The sensor will soon send a signal to the display unit and the two units will be
synchronized. It may take a few minutes for synchronization to be complete.
(100 meters)
(330 feet maximum)
The outdoor sensor MUST BE PLACED OUTDOORS to observe
outdoor temperatures and humidity. The sensor must be placed less
than 330 feet (100 m) from the display unit. The sensor is water
resistant and is designed for general outdoor use. However, to
extend the life of the product, place the sensor in an area protected
from direct weather elements.
To ensure an accurate outdoor temperature measurement, be sure
the sensor is placed out of direct sunlight and away from any heat
sources.
There are 2 placement options for the sensor. You may hang it using
one of the two integrated hang holes, or use string (not included) to
hang it from a suitable location like a well covered tree branch.
Placement of Sensor