Atomic clock, Set the time & date, Select measurement units – AcuRite 00634 Weather Station User Manual
Page 8
8
Atomic Clock
AcuRite atomic clocks use a radio-controlled signal to synchronize to the correct time
broadcast by the National Institute of Standards and Technology (NIST) Radio Station
WWVB, located near Fort Collins, Colorado. WWVB broadcasts the current time and
date with split-second accuracy.
This AcuRite atomic clock and calendar will maintain the correct time and date,
and automatically update for daylight saving time to provide the most accurate
timekeeping standard possible.
Please note: The atomic signal generally takes a few hours to synchronize, so it is
important to manually set the time and date after powering on the display.
Set the Time & Date
Press AND HOLD the “SET” button for 5 seconds to enter SET MODE. Once in set
mode, the preference you are currently setting will blink on the display.
To adjust the currently selected (flashing) item, press the “ + ” button (press and
HOLD to fast adjust).
To save your adjustments, press and release the “SET” button again to adjust the next
preference. The preference set order is as follows:
TIME ZONE (PST MST CST EST)
DST (Daylight Saving Time ON OR OFF)
CLOCK HOUR
CLOCK MINUTE
CALENDAR YEAR
CALENDAR MONTH
CALENDAR DATE
You will automatically exit SET MODE if no buttons are pressed for 30 seconds. Enter
basic setup mode at any time by pressing and holding the “SET” button.
Select Measurement Units
To select between U.S. standard units or imperial units, press the “SCALE” button.
Please note: The “WIND SPEED” history chart only displays data in “mph”.
Measurement
U.S. Standard Units
Imperial Units
Temperature
Degrees Fahrenheit (ºF)
Degrees Celsius (ºC)
Barometric Pressure
inHg (inches of mercury)
hPa (Hectopascal)
Wind Speed
Miles per hour (mph)
Kilometers per hour (kph)