AcuRite 00277 Thermometer - Manual (Page 7)

7
Warning Messages
When display reads “LO BAT”, replace batteries.
Check Probe
“CHECK PROBE” indicates a probe error and is shown with a diagnostic code:
Diagnostic
Code
Problem Solution
No
Probe cord is not connected
to the thermometer.
Verify cord connection is secure
or reconnect cord.
SC
Probe cord is not functioning
properly. Cord may have
been damaged or exposed to
extreme heat.
Check the wire and connection
for damage or excessive heat.
Replace cord.
Troubleshooting
Problem Possible Solution
Inaccurate
temperature
• Use standard alkaline batteries. Do
not use heavy duty or rechargeable
batteries.
Check Probe • Review Warning Messages (page 7)
Display screen
not working
• Check that the batteries are installed
correctly. Batteries may need to be
replaced.
Care & Maintenance
Store in a dry location at room temperature. Clean thermometer with a soft,
damp cloth. Temperature probe should be wiped clean with warm water
immediately after direct contact with foods.
DO NOT place display unit on or near hot surfaces. DO NOT heat beyond
thermometer’s temperature capacity. DO NOT use in oven. DO NOT wash in
dishwasher. DO NOT immerse in water or use caustic cleaners or abrasives.
DO NOT allow any part of the temperature probe or probe wire to come into
direct contact with flames or flare-ups. DO NOT bend or crimp the temperature
probe cord. DO NOT lift or move the thermometer by the temperature probe
wire connection.
If your AcuRite product does not operate properly after trying
the troubleshooting steps, visit www.AcuRite.com or call
(877) 221-1252 for assistance.