Mode button (ma90z power unit), Max inflate button (ma95z power unit) – Activeforever Invacare microAIR Lateral Alternating Pressure Mattress & Compressor (microAIR Mattress with Compressor 36 x 80 x 15) User Manual
Page 18

SECTION 2—OPERATION
MA90 and MA95 Series Mattresses
18
Part No 1148139
Mode Button (MA90Z Power Unit)
1. Press the Mode button (
) to select the Max Inflate Mode or the Low Air Loss mode.
• Max Inflate Mode ‐ In this mode, the mattress inflates rapidly to maximum
firmness (pressurized to 35 ± 6 mmHg). A series of beeps sound every three
minutes as a reminder that the Max Inflate mode is active. After 30 minutes, the
Max Inflate mode deactivates and the control unit defaults to the previous setting.
NOTE: It takes 5‐10 minutes for the MA90Z mattress to inflate fully (inflation time depends
on size of mattress).
NOTE: Max Inflate mode can be manually disengaged by pressing the Max Inflate button.
This will deactivate the Max Inflate LED.
NOTE: It is recommended that Max Inflate setting be used during patient ingress/egress,
patient wound care, patient turning or patient cleaning.
• Low Air Loss Mode ‐ In this mode, the mattress goes into on‐demand low air loss
relief mode.
Max Inflate Button (MA95Z Power Unit)
1. Press the Max Inflate button (
) to select the max inflate mode and inflate the
mattress rapidly to maximum firmness (pressurized to 35 ± 6 mmHg). A series of
beeps sound every three minutes as a reminder that the Max Inflate mode is active.
After 15 minutes, the Max Inflate mode deactivates and the control unit defaults to the
previous setting.
NOTE: It takes 25‐60 seconds for the MA95Z mattress to inflate fully (inflation time depends on
size of mattress).
NOTE: It is recommended that Max Inflate setting be used during patient ingress/egress, patient
wound care, patient turning or patient cleaning.
2. Perform one of the following:
• MA90Z Power Unit ‐ Press the Max Inflate button again to manually disengage
Max Inflate mode.
• MA95Z Power Unit ‐ Select a different setting to exit Max Inflate mode, or press the
Max Inflate button again.
NOTE: This will deactivate the Max Inflate LED.