Activeforever Turning Leg Caddy Pilot Knee Walker - Manual (Page 2)

BRAKE: The brake is engaged by depressing the brake lever on the handlebar. The braking
wheel must be in contact with the floor, and the brake works best with weight on the TLC. To
set the brake, squeeze the brake lever and push down the button on the brake lever holder. To
unlock the brake, squeeze the brake lever.
Brake Adjustment: For packing, the hand lever for the brake will be in an upright position.
Use the 3/16 Allen wrench provided to loosen the hand lever and reposition it to a comfortable
use position, re-tightening with the Allen wrench, as necessary. The pressure of the brake
mechanism on the brake wheel should be enough so that, when the hand lever is in the fully
squeezed position, the brake wheel does not turn but is not overly tight. The tightness can be
adjusted with the nuts at either end of the brake cable. Turning the screw clockwise will loosen
the brake and turning the screw counter clockwise will tighten it (see parking brake instructions).
WARNING: Because of the light weight of the TLC, use of the hand brake while in motion
may cause an abrupt stop.
WARNING: Do not use the TLC on or near stairs or while using mind-altering drugs or
alcohol or while suffering from dizziness.
WARNING: Do Not use the TLC to pull yourself up from a seated or other position. The TLC
is intended for use with a person in place on the scooter.
WARNING: Use caution when moving from carpeted to hard surface floors and on any rough
surfaces or when changing levels (for example, moving from a curb to the street and back onto
the sidewalk) Check the TLC frequently for any loose cotter pins, clevis pins or loose nuts or
bolts and the quick-release clamp on the T-tube. Do not use the TLC if any pins are missing.
Round About Mobility Mate, LLC
Operating Instructions
Page - 2
www.ActiveForever.com